Common faults and treatment methods of crane remote control
All equipment that can be controlled by electrical switch can be used for long-distance wireless control using industrial wireless remote control system, industrial controller remote control distance of 100 meters can meet most of the operating conditions control requirements.
So, driving remote control in the use of what common faults, how to solve these faults in a timely manner?
The following will be described in more detail:
1, ** has been plugged into the power socket, but the indicator light is still not flashing, there is no action output
Pressing into the spin out of the emergency stop is pressed down, normal operation when the need to spin Chi Yu stop Shanfang have action output
2, press the ** button but no action output, the indicator light also does not blink
Check that the power socket is plugged in
3, ** Can not be remote control, the original wire control can not be controlled
Please repair the Skycar when the Skycar fails.
4, ** has been plugged into the power socket, the emergency stop Shanyi is screwed out, but the indicator light is still not flashing, there is no action output You can try using sandpaper to gently grind the contact point of the battery compartment, or replace a new set of batteries to operate again, noting whether the positive and negative polarity of the battery is consistent with the one shown above the battery compartment.
Try pressing the function button to check if the power led flashes at a speed of 0.3 seconds every 2 seconds, and the green light should normally be flashed.
5, when the ** in the power transmission of the SQ lamp only bright green The ** continues to launch, or **CPU is in protected mode, allowing the total power supply of the Skycar to be powered off and then turned on and reset. If there is still no improvement, please contact your supplier immediately.
If the result of the inspection fuse is not burned is possible cause: there is a problem with the power input, please check whether the input voltage is in AC220V±10[%], if not this problem need to find out the cause of the voltage anomaly.
6, when the ** in the power transmission LED lights do not light The power supply does not enter the **, or the power fuse burns, if it has been burned please replace a new power fuse
